MeshCore

3182 Commits

11 Branches

98 Tags

220 MiB

Tree: d2fd1fdaa6

Commit Graph

Author	SHA1	Message	Date
Naomi Smith	3af5ffe119	Fix GPS and LEDs on ThinkNode M3 GPS support was implemented incorrectly for the ThinkNode M3. The reset pin was being driven when it should be left floating for this unit. The enable pin also wasn't being picked up by `MicroNMEALocationProvider` because of a mismatch in constant naming conventions. I did a general cleanup of the GPS and ThinkNode M3 bring-up code so that constant names line up and "*_ACTIVE" constants are used consistently vs hardcoding `HIGH`/`LOW`. After making these changes, serial data immediately starts streaming in from the NMEA on boot and GPS detection just works. LED handling was also not quite right for the ThinkNode M3. The LoRa TX LED was being driven high to turn it on when it should actually be driven low. I changed the code to use the `LED_STATE_ON` constant and also added a little code to the shutdown path to properly make sure that all LEDs are turned off. Tested and confirmed working on real hardware. Resolves both #1864 and #2879.	3 weeks ago
Florent	bde4fc3a23	thinknode_m3: initial commit	8 months ago

Author

SHA1

Message

Date

Naomi Smith

3af5ffe119

Fix GPS and LEDs on ThinkNode M3

GPS support was implemented incorrectly for the ThinkNode M3. The reset
pin was being driven when it should be left floating for this unit. The
enable pin also wasn't being picked up by `MicroNMEALocationProvider`
because of a mismatch in constant naming conventions. I did a general
cleanup of the GPS and ThinkNode M3 bring-up code so that constant names
line up and "*_ACTIVE" constants are used consistently vs hardcoding
`HIGH`/`LOW`. After making these changes, serial data immediately starts
streaming in from the NMEA on boot and GPS detection just works.

LED handling was also not quite right for the ThinkNode M3. The LoRa TX
LED was being driven high to turn it on when it should actually be
driven low. I changed the code to use the `LED_STATE_ON` constant and
also added a little code to the shutdown path to properly make sure that
all LEDs are turned off.

Tested and confirmed working on real hardware.

Resolves both #1864 and #2879.

3 weeks ago

Florent

bde4fc3a23

thinknode_m3: initial commit

8 months ago

2 Commits (d2fd1fdaa6045bd16625c19822df27c256f892a2)